#Installing a dimmer switch how to

Step 7: Put the plate back in place and put the screws back in. Step 6: Screw the switch back into the electrical box. This can get annoying, since the wires are thick and there’s not a lot of room in the box so if you need to, gently push the wires in with your screwdriver.

#Installing a dimmer switch how to

The steps are basically the same for how to install a switch. Step 5: Ease all the wires back into the hole and then slide the switch in after them. Install the New Dimmer and a Grounding Clip. When swapping out a switch for a dimmer, dont forget you need to make sure the light bulbs or lamps you are using are compatible with the dimmer you use. (It doesn’t matter which connects to which.) Finally, connect the black wire from the switch with the wire you marked with tape. Then connect the two red wires from the new switch with the two wires you did not mark with tape. THREE-WAY SWITCH: This part of the video focuses on the three-way switch. Select a dimmer switch that has a rated capacity high enough to handle the combined wattage of all the bulbs in the.It doesn’t matter which connects to which. Gently pull on each wire to make sure they don’t come out, then wrap them with a couple loops of electrical tape. (If there is less than a half-inch of bare wire showing, expose more using a wire stripper.) Line up the exposed parts of both wires, put the cap over them, then twist until the cap is tight. Your dimmer will probably use a wire cap to do this. If you need to straighten them, just do it with a pair of pliers.) Connect the green wire from the switch to the green wire in the wall. (You can ignore the part about cutting off the ends of the wires. SINGLE-POLE SWITCH: This video shows the process.

Step 4: It’s time to connect the wires from the new switch to the wires in the wall. Contact a Melbourne CBD Electrician now for a quote on Dimmer Switch Installation Ph: 1300 SPHERE. Mark it with a piece of tape, then disconnect the wires. Before you go rushing out to buy the first dimmer switch you see on the shelf, it is essential you first look at the 3 key ideas we have listed below to ensure you come home with the right dimmer switch to suit your needs. That’s the hot wire, which carries electricity to the switch. Locate the wire that is connected to the black screw on the old switch. If you have a three-way switch, there will be four wires (typically red, black, green, and striped, but don’t worry if yours are different). You can separate the wires from the old switch - either by loosening the screws on the old switch or by unscrewing the wire caps - and skip to the next step. If it’s a single-pole switch, there will be three wires coming out of the wall (typically red, black, and green). Step 3: Here’s where it matters what kind of switch you have.

For this type of switch, loosen the screws on the side of the switch then pull the wires out.